Bow quiver foam ?

[SS Snuffer]

I'm changing the foam in my Great Northern quiver. What holds it in place, glue? Dum question but I'm sure someone here has done it. I'm changing from 3 blade to 2 and would like to save the old in case I want to go back to 3 blade.

Thanks guys

[TSP]

Mine was spot-glued, it came out fairly easily.  No need to replace the entire foam, simply cut off the top inch or so laterally, glue on a replacement 'slab' of foam to match what you cut off, then trim the replacement piece to shape.  Can use hot glue (in spots, not everywhere) to hold the finished product in the hood when done.

[SS Snuffer]

Thanks Tony  much appreciated!

[Pat B]

A small piece of double sided tape will work too. 

[Kirkll]

This glue works very nice for rest and strike plate materials on risers, and should work well for your foam insert as well...just go easy on it.


https://www.acehardware.com/departments/paint-and-supplies/tape-glues-and-adhesives/glues-and-epoxy/17338?store=15157&gad_source=1&gbraid=0AAAAADtqLJHotM7NIYqs3_7MCUfIx0ZEF&gclid=Cj0KCQjwlvW2BhDyARIsADnIe-JE1tc7Wv58CAmVWdT2A3CbQQYoyV94SgVNc1gNWoIqMJZvwl7O24kaAi14EALw_wcB&gclsrc=aw.ds