Thunder horn small fry and Snuffers?

[Ryan Rothhaar]

Going to pick up another Linx quiver from thunder horn, anyone use a small fry with Snuffers or similar sized 3 blades? Can you get 3 of them in there and buried in the foam? I have one that is the standard size, would like to get the smaller one this time if I can get 3 full sized Snuffers in it.


Thanks!

R

[cacciatore]

Ryan, I use a big one and 2 smaller BHs as a back up, obviously with the same weight, since isn't so common to have a second chance.

[Bullchaser1]

I have the small fry for deer/ turkey. I run 3 vpa 3 blade and a judo point with no problems. Vpa's are 1 1/8".
J

[STICKBENDER98]

[attachment=1]



Hey Ryan, this is a GN quiver with 5 150 grain Snuffers in it, not sure size wise how it compares to the Small Fry you're looking at.


Jason

[meathead]

They will fit. A little tight but not too bad.

[KAZ]

I'm running VPA 250 Grain 1-1/4" 3 Blade screw-in in mine without issue. I push them till back of the blade is flush with foam and never even tried further but I'm certain I'm not hitting anything interior... On wide three blade I usually straddle one horizontal blade with the Y of the other broadhead next to it... I also can line up wide two blades with one of the 3 blades so I can fit either 2 blades or 3 Blades, all 1-1/4" wide... 4 - Broadheads, 1 small game thumper external with piggy backer or you have room in the hood to flip arrow Nock in and thumper out or field point in, nock out. Probably space to find a spot for thumper but I don't auger a big spot...

[Ryan Rothhaar]

Ok, thanks for the info guys, sounds like a winner!

R

[Ryan Rothhaar]

I really like the linx quiver, and the smaller hood will be nice.

R

[David McLendon]

They will fit but as said it's tight and they do cut the foam up quite a bit. As a result I pulled out the low density stock foam and replaced it with Walmart Yoga Block foam. It grips better and is a lot quieter. I also mark the foam with a Sharpie for the blades so they are always going back into the same slots instead of cutting new ones.