I have 2 risers I glued up with EA-40. Fancy curve cut out on a jig I made. Quite proud of them. Due to my stupidity and a jointer fence out of square I now have 2 risers 1-3/4 inch wide. I need to make them 2" again so I was going to cut them down the middle and put a 1/4" piece of maple in the center. Can I reheat the blanks to reglue with EA-40 or should I do something else?
Just lay it up without heat... I rarely cook a riser even doing footings. I do put them in my spray booth and keep them at about 70 degrees or more overnight before milling them... The stuff doesn't need heat to cure out properly.
Kirk x 2
I dont see a problem reheating-Most of my Hill`s have multiple glue-ups-Sometimes up to three :)
My question is why do you need a 2" thick riser?
You can reheat it wont hurt it a bit Ive had some of mine in the heat box as many as 5 times . I would not reheat it with more than the original temps .