Trad Gang

Main Boards => The Shooters FORM Board => Topic started by: Kx199 on March 15, 2015, 04:58:00 PM

Title: Form question
Post by: Kx199 on March 15, 2015, 04:58:00 PM
Bow hand. Is it best to lock your elbow or have a slight bend? I try both but feel that I have a hard time duplicating my shot cycle with a slightly bent bow hand. I have decent results with it, but it's easy to bend too much, not being consistent.
Thanks guys!

Loving the forum and the 70 degree weather we are having today!
Title: Re: Form question
Post by: jt85 on March 15, 2015, 05:04:00 PM
Not an expert by any means but I personally keep a slight bend in my elbow.
Title: Re: Form question
Post by: longbow fanatic 1 on March 15, 2015, 05:37:00 PM
I lock my elbow, then rotate my elbow to 9 o'clock (right handed shooter). It's very repeatable.
Title: Re: Form question
Post by: moebow on March 15, 2015, 07:01:00 PM
My take.

Locked joint = willing to sacrifice the joint to the task at hand.

Bent elbow, bow held with muscle alone = less consistent.

Elbow straight BUT NOT LOCKED = bone on bone and most consistent.  (yes, elbow pronated (rolled in).

Arne
Title: Re: Form question
Post by: McDave on March 15, 2015, 10:20:00 PM
+1 elbow straight but not locked.
Title: Re: Form question
Post by: njloco on March 17, 2015, 07:19:00 AM
It's bent but not locked, like what Arne and McDave say above, you'll just have to play with it. If you have a fixed vertical bar, like on a metal fence. Grab hold of it, lean on it. You'll notice if your using your muscle's it will get uncomfortable pretty quick. Now while your holding it straighten your arm out but don't lock it, now just slightly rotate your elbow so it's horizontal to the ground. What you should end up with is a slight bend in the elbow, but the pressure is really resting on the bone !

Good luck !
Title: Re: Form question
Post by: slowbowjoe on March 19, 2015, 10:49:00 PM
Been working with bow arm straight but not locked, like Moebow and McDave are saying also  (I listen to those guys a lot).
I have my anchor fairly consistent, but I'm still trying to establish consistency with my bow arm - straight but not bent is what I'm working with presently for that.